2-Port 100Gbps And 10-Port 10Gbps Otn And Packet Line Card - Cisco NCS 4000 Series Hardware Installation

2-Port 100Gbps and 10-Port 10Gbps OTN and Packet Line Card

LED
Attention
Port
2 The Attention LED can be lit only by using the hw-module attention-led location CLI command, which is useful for identifying and verifying which card needs
attention.
Physical Characteristics
• Height— 11.05 in. (280.6 mm)
• Width— 1.55 in. (39.4 mm)
• Depth— 14.25 in. (362 mm)
• Weight— 8.48 lb (3.85 kg)
2-Port 100Gbps and 10-Port 10Gbps OTN and Packet Line Card
The 2-port 100 Gbps and 10-port 10Gbps (NCS4K-2H10T-OP-KS) OTN and packet line card supports the
following port configurations:
• 2-ports of 100 Gbps with CPAK optics
• 1-port of 100 Gbps with CPAK optics and 10-ports of 10 Gbps SFP+ optics
The CPAK 0 port cannot be disabled. The 10SFP+ ports can be used only when and only the CPAK 1 port is
disabled.
The card supports OTN and packet aggregation where both TDM switching and packet forwarding capabilities
are combined in a single card. Hence, it can terminate both OTN control plane traffic as well as packet control
plane traffic.
The card supports up to two-level ODU4, ODU2, ODU2e, ODU1, ODU0, and ODUFlex nested switching
functions by interconnecting with the centralized agnostic switch fabric; 100-Gigabit Ethernet signals are
mapped using generic mapping procedure (GMP) or Generic Framing Procedure - Framed (GFP-F) over
ODU4 according to ITU-T G.709 v3 (Section 17.7.5). The 10 GE signals are mapped using GFP-F mapping
over ODU2 and BMP mapping over ODU2e respectively.
Hardware Installation Guide for Cisco NCS 4000 Series
74
State
2
Blue
Off
Green
Yellow
Off
Installing Route Processor Cards, Fabric Cards, and Line Cards
Description
The card needs attention.
The card does not need attention.
The link is up (including internal
loopback).
The link is down or a hardware
failure has occurred.
The slice is unprovisioned by
software, the optics module is
missing, or the slice has been
powered down.