Switching The Warning Tone; Switching The Auxiliary Setting; Switching The Dimmer Setting; Switching The Rear Output Setting - Pioneer DEH-P44 Operation Manual

Initial Settings

Switching the warning tone

If the front panel is not detached from the head
unit within five seconds of turning off the igni-
tion, a warning tone will sound. You can turn off
this warning tone.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
on or off with 5/∞.
2 Select
WARN
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
).
WARN :ON

Switching the auxiliary setting

It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
in the display.
on or off with 5/∞.
2 Select
AUX
Pressing 5/∞ will switch
off and that status will be displayed (e.g.,
).
AUX :ON

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can switch dimmer on or off.
.
WARN
WARN
between on
WARN
.
AUX
appears
AUX
between on and
AUX
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
on or off with 5/∞.
2 Select
DIMMER
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
).
DIMMER :ON

Switching the rear output setting

This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer output
on (refer to Using subwoofer output on page 30).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this set-
ting.
1 Press to select the rear output
FUNCTION
setting mode.
Press repeatedly until
FUNCTION
appears in the display.
• If the rear output setting has been set to the
subwoofer then
FRT+S/W
2 Select full-range speaker or subwoofer
with 2/3.
Pressing 2/3 will switch between
(full-range speaker) and
and that status will be displayed.
.
DIMMER
DIMMER
between on
DIMMER
FRT+REAR
will be displayed.
FRT+REAR
(subwoofer)
FRT+S/W
En
Section
07
33