Equalizer Curve Fine Adjustment; Adjusting Bass - Pioneer DEH-P44 Operation Manual

Audio Adjustments

Equalizer curve fine adjustment

You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (
EQ-LOW/EQ-MID/EQ-
).
HIGH
Level (dB)
Center frequency
1 Press and hold until frequency and
AUDIO
the Q factor (e.g.,
F-80 Q-1W
display.
2 Press to select the desired band for
AUDIO
adjustment.
Press repeatedly to switch between the
AUDIO
following bands:
(low)—
EQ-LOW EQ-MID
3 Press 2/3 to select the desired frequency.
Press 2 or 3 until the desired frequency
appears in the display.
— — —
LOW: 40 80 100 160
— — —
MID: 200 500 1K
— — —
HIGH: 3K 8K 10K
4 Press 5/∞ to select the desired Q factor.
Press 5 or ∞ until the desired Q factor appears
in the display.
— — —
2N 1N 1W 2W
Note
• If you make adjustments when a curve other
than is selected,
CUSTOM2
is updated.
Q=2W
Q=2N
Frequency (Hz)
) appears in the
(mid)— (high)
EQ-HIGH
(Hz)
(Hz)
2K
(Hz)
12K
curve
CUSTOM1

Adjusting bass

You can adjust the cut-off frequency and the
bass level.
In mode, bass adjustment affects only the
FRT1
rear output: front output cannot be adjusted.
1 Press to select
AUDIO
Press until
AUDIO BASS
2 Select the desired frequency with 2/3.
Press 2 or 3 until the desired frequency
appears in the display.
— — — (Hz)
40 63 100 160
3 Press 5 or ∞ to adjust the bass level.
Each press of 5 or ∞ increases or decreases
the bass level. – displayed as the level is
+6 –6
increased or decreased.
.
BASS
appears in the display.
En
Section
06
29