Table of Contents
Advertisement
Installation Steps
Default password:
W
a
l
l
P
l
a
t
e
I
n
s
W
a
l
l
P
l
a
t
e
I
n
s
Tools Required:
Number 2 Philips head screwdriver
Note: if using a power drill, set the torque clutch to 5 in-lbs.
Components provided with the MC-802 WallPlate:
1 – MC-802 WallPlate
1 – RJ11 wall jack mounting adapter
1 – 150mm (6") RJ11 pigtail cable
1 – RJ11 blanking plug
2 – 6-32 thread forming Philips head screws, 0.375"
Components required to purchase:
Regulated 12V power supply. Use of the wrong power supply could result in damage to your WallPlate
unit. Please order a small quantity of regulated 12V power supplies from Motorola PBN to use during
installation.
If you do not have the correct regulated 12V power supply – STOP. Order a regulated 12V power supply
from your Motorola PBN sales representative.
Step 1
1. Loosen screws on wall plate approximately 6mm (1/4")
2. Attach the bracket using the keyhole slots
3. Tighten screws until the bracket is firmly attached, do not over tighten
t
a
l
l
a
t
i
o
n
t
a
l
l
a
t
i
o
n
<blank>
Advertisement
Table of Contents
