Configuring Network Event Settings - Honeywell HDZ302D User Manual

68 | equIP® Series 30x Zoom WDR PTZ Camera User Guide

Configuring Network Event Settings

There are two types of network events:
You can configure settings for each type of event.
To enable network event detection:
1.
2.
3.
4.
5.
6.
7.
8.
www.honeywell.com/security
• Network Disconnected: The camera is offline.
• IP Conflict: The camera has the same IP address as another device on the network.
On the Network tab, select the event type that you want to configure from the Event
Type list (Network Disconnected or IP Conflict).
Select the Enable check box.
In the IP Address field, enter the IP address of the headend, and in the Time field, enter
the countdown time. If no connection is established with the IP address within the
specified time, the system will will detect a network disconnection event.
To start recording video when the event is detected, select the Record check box.
In the Record Delay field, enter the number of seconds that the system will continue to
record video after the event has ended. Enter a value between 10 and 300.
To generate an alarm output when the event is detected, select the Alarm Output check
box and select the alarm output(s) to be activated.
In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after the event has ended. Enter a value between 10 and 300.
Click Save to apply the settings.