Configuring The Live Interface - Honeywell HDZ302D User Manual

Configuring the Live Interface

You can configure the Live interface using the configuration controls located in the lower left
corner of the screen, immediately below the video window
Note The first time you log into the web client, follow the on-screen instructions to
download and install the web browser plug-in.
Figure 2-2 Live Configuration Toolbar
Table 2-1 Live Configuration Controls
Image Opens the Image Adjustment panel.
Adjustment
Move the sliders to adjust the image
brightness, contrast, hue, or saturation.
Click the – and + signs to make fine
adjustments. To restore the settings to
their default values (64), click Reset.
Note These settings only apply to the
Original Size Displays the video at actual size (the exact dimensions are
determined by the stream resolution).
Full Screen Displays the video in full-screen mode. Double-click (or press Esc)
to exit full-screen mode.
Width:Height Displays the video in its original size (Original) or fitted to your
Ratio screen (Adaptive).
Fluency Sets the video fluency level (Realtime, Normal, or Fluency).
Select a fluency level based on the capabilities of your network.
For example, if your connection is slow, selecting Fluency will
prioritize smoothness over image quality.
Rules Info Tracks movement in the video window when intelligent video
surveillance (IVS) is enabled (see
page 73).
PTZ Opens the PTZ Control, Joystick, and PTZ function panels.
Logging In and Viewing Live Video | 21
(Figure
client end. To change the settings at the camera end, go to
Setup > Camera Setup > Conditions > Picture.
2-2).
Configuring Audio Events
800-22456 - A - 04/2017
on