Panel Layout - TP-Link AURANET CAP300-OUTDOOR Installation Manual

Panel Layout

GND
The Grounding Terminal is used for lightning and ESD protection. Use a grounding
cable to connect the Grounding Terminal to earth ground.
ETHERNET
The port is used to connect to a PSE (Power Sourcing Equipment), such as a PoE
switch, for both data transmission and Power.
FIT FAT
The FIT/FAT switch is used to toggle the CAP's working mode. The toggling of the
mode will reboot the CAP.
In FIT mode, APs can be centrally managed by TP-Link's wireless controller. The
default FIT mode is used when you want to deploy a large wireless network.
In FAT mode, you can log in to CAP's webpage to manage the CAP alone. The FAT
mode is used in a small wireless network. The AP cannot be managed by wireless
controller in FAT mode.
RESET
With the device powered on, press and hold the button for about 8 seconds until
the LED flashes red, then release the button. The device will restore to factory
default settings.
Grounding Shielded Ethernet
Terminal Port LAN
2
FIT FAT RESET