Carrying Out Auto Ta And Eq - Pioneer DEH-P9800BT Operation Manual

High power dsp cd/mp3/wma/aac player with bluetooth wireless technology, rds tuner and multicd control
Hide thumbs Also See for DEH-P9800BT:
Table of Contents

Advertisement

Available languages

Available languages

Audio Adjustments

Carrying out auto TA and EQ

CAUTION
Never use the microphone for hands-free phon-
ing to operate the auto TA and EQ. Using the mi-
crophone unfit for the auto TA and EQ may
damage the speaker. Be sure to connect the
AUTO TA&EQ microphone into the microphone
input jack.
1
Stop the car in a place that is as quiet
as possible, close all doors, windows and
the sun roof, and then turn the engine off.
If the engine is left running, engine noise may
prevent correct auto TA and EQ.
2
Fix the supplied microphone in the cen-
ter of the headrest of the driver's seat, fa-
cing forward, using the belt (sold
separately).
The auto TA and EQ may differ depending on
where you place the microphone. If desired,
place the microphone on the front passenger
seat to carry out auto TA and EQ.
3
Turn the ignition switch to ON or ACC.
If the car's air conditioner or heater is turned
on, turn it off. Noise from the fan in the air
conditioner or heater may prevent correct auto
TA and EQ.
# Press SOURCE to turn the source on if this
unit is turned off.
4
Select the position for the seat on
which the microphone is placed.
Refer to Using the position selector on page
82.
# If no position is selected before you start auto
TA and EQ, Front Left is selected automatically.
5
Press SOURCE and hold until the unit
turns off.
If anything is connected to the microphone
input jack, disconnect it.
6
Press and hold EQ to enter the auto TA
and EQ measurement mode.
7
Plug the microphone into the micro-
phone input jack on this unit.
AUTO TA&EQ microphone
8
Press MULTI-CONTROL to start the auto
TA and EQ.
9
Get out of the car and close the door
within 10 seconds when the 10-second
count-down starts.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completed in about six minutes.
# To stop auto TA and EQ, press
MULTI-CONTROL again.
# To cancel auto TA and EQ part way through,
press BAND.
Section
14
91
En

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents