Tuner; Listening To The Radio; Tuner Listening To The Radio - Pioneer DEH-P9800BT Operation Manual

Tuner

Listening to the radio

1 1 1 2 2 2 2
6 6 6
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
This unit's AF (alternative frequencies search)
function can be turned on and off. AF should
be off for normal tuning operation (refer to
page 23).
1 Stereo (5) indicator
Shows when the selected frequency is
being broadcast in stereo.
2 LOC indicator
Shows when local seek tuning is on.
3 Band indicator
Shows which band the radio is tuned to,
MW/LW or FM.
4 Preset number indicator
Shows which preset has been selected.
5 Frequency indicator
Shows the frequency to which the tuner is
tuned.
6 Signal level indicator
Shows the radio wave strength.
1 Press SOURCE to select the tuner.
Press SOURCE until you see Tuner displayed.
3 3 3 3 4 4 4 4 5 5 5 5
2 Press BAND to select a band.
Press BAND until the desired band is dis-
played, FM-1, FM-2, FM-3 for FM or MW/LW.
3 To perform manual tuning, push
MULTI-CONTROL left or right.
The frequencies move up or down step by
step.
4 To perform seek tuning, push and hold
MULTI-CONTROL left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
MULTI-CONTROL left or right.
# If you push and hold MULTI-CONTROL left or
right you can skip stations. Seek tuning starts as
soon as you release MULTI-CONTROL.
Section
04
19
En