Supra SL Owner's Manual page 41

Section 7
Starting & Operation
A standard pre-starting procedure should be always be followed before the first start-up of the day.
1. Check the engine oil level.
2. Check for gasoline fumes in bilge or engine compartment.
3. Operate engine blower for 4 minutes before starting the engine to remove any fumes.
4. Check manual and automatic operation of bilge pumps. Make sure bilge areas are empty.
Other items might also be inspected, depending on the boat and its use. It is advisable to formulate a check list
particular to the equipment and operation of your boat.
REFER TO THE BOATMAN'S CHECKLIST OF THIS MANUAL, LOCATED IN THE GLOVEBOX OF YOUR BOAT.
Consult the local Coast Guard Auxiliary or Power Squadron for full details on boating safety.
NOTE: Add-on electrical accessories should never be connected to the ignition terminal or ignition circuit.
IMPORTANT
: DO NOT continue to operate the starter for more than 15 seconds at a time without pausing to allow the starter motor
to cool down for at least 2 minutes. This will also allow the battery to recover between starting attempts. PLEASE REFER TO ENGINE
OWNER'S MANUAL FOR ADDITIONAL DETAILS.
BEFORE STARTING ENGINE, BE SURE THAT THE SHIFT SELECTOR IS IN NEUTRAL.
Please refer to the engine manual before starting.
Do not start engine if gas fumes are present.
40
©2017 Skier's Choice, Inc.