GMC YUKON 2018 Owner's Manual page 67

66 Seats and Restraints
1 or 2 corresponds to the driver
number. See Identifying Driver
Number in this section.
5. Repeat Steps 1 4 for a second
driver using 1 or 2.
To save positions for
exit features, repeat Steps 1 4
using . This stores the positions
for getting out of the vehicle.
Save preferred memory feature
positions to both 1 and 2 if you are
the only driver.
Manually Recalling Memory
Positions
Press and hold 1, 2, or
the previously stored memory
positions.
To stop manual recall movement,
release 1, 2, or . Recall can also
be stopped by pressing a power
seat, SET, power mirror control,
power steering wheel control,
or adjustable pedal control,
if memory equipped. The driver or
passenger side mirror must be
selected.
Auto Memory Recall
The vehicle identifies the number of
the current driver s RKE transmitter
(1 8).
See Remote Keyless Entry (RKE)
System Operation (Key Access)
and easy
0 31 or Remote Keyless Entry
(RKE) System Operation (Keyless
Access) 0 33. If the RKE transmitter
is 1 or 2, and Auto Memory Recall is
programmed on in vehicle
personalization, the positions saved
to the same memory button number
1 or 2 are automatically recalled
when the ignition is turned on,
or turned from off to ACC/
ACCESSORY. RKE transmitters 3 8
to recall
will not provide automatic memory
recalls.
To turn Auto Memory Recall on or
off, see "Vehicle Personalization
Settings" previously in this section
and Vehicle Personalization 0 158.
The transmission must be in
P (Park) to initiate Auto Memory
Recall. Auto Memory Recall will
complete if the vehicle is shifted out
of P (Park) prior to reaching the
stored memory position.
To stop Auto Memory Recall
movement, turn the ignition off or
press any of the following memory
controls:
Power seat
Memory SET, 1, 2, or
Power mirror, with the driver or
passenger side mirror selected
Power steering wheel,
if equipped
Adjustable pedals, if equipped
If the stored memory seat position
does not automatically recall or
recalls to the wrong positions, the
driver s RKE transmitter number (1
or 2) may not match the memory
button number that positions were
saved to. Try storing the position to
the other memory button or try the
other RKE transmitter.
Easy Exit Recall
Easy Exit Recall is not linked to an
RKE transmitter. The position stored
to is used for all drivers. To turn
Easy Exit Recall on or off, see