GMC YUKON 2018 Owner's Manual page 125

124 Instruments and Controls
OFF : Turns the windshield
wipers off.
8
: For a single wipe, turn to
then release. For several wipes,
8
hold the band on longer.
Clear ice and snow from the wiper
blades before using them. If frozen
to the windshield, carefully loosen or
thaw them. Damaged wiper blades
should be replaced. See Wiper
Blade Replacement 0 303.
Heavy snow or ice can overload the
wiper motor. An internal circuit
breaker to the motor will stop the
motor until it cools down.
Wiper Parking
If the ignition is turned off while the
w 1
wipers are on , , or
they will immediately stop.
z
If FRONT is then moved to
OFF before the driver door is
opened or within 10 minutes, the
wipers will restart and move to the
base of the windshield.
If the ignition is turned off while the
wipers are performing wipes due to
windshield washing or Rainsense,
8
,
the wipers continue to run until they
reach the base of the windshield.
Rainsense
With Rainsense, a sensor near the
top center of the windshield detects
the amount of water on the
windshield and controls the
frequency of the windshield wiper.
Keep this area of the windshield
clear of debris to allow for best
system performance.
INT : Turn the
band on the wiper lever to adjust the
sensitivity when Rainsense is
turned on.
INT,
Turn the band up for more
sensitivity to moisture.
Move the band out of the
position to deactivate Rainsense.
z
Rainsense on or off. When turned
z
FRONT
on and
Rainsense wipe sensitivity positions
the wipers can be adjusted for more
or less sensitivity to moisture. When
turned off, the wipers operate as
timed intermittent wipers and can be
adjusted for more or less frequent
wipes.
z
If
ignition is turned on, or if the ignition
is in on and the
is in one of the sensitivity settings
Turn the band down to lower INT
setting for less sensitivity to
moisture.
AUTO : Press to turn
z
FRONT is in one of the
AUTO is turned on when the
z
FRONT band
INT