JVC UX-QD70S Service Manual page 33

3.3.10 Removing the slide bar and cartridge holder assembly
(See fig.15 and 16)
• Remove the MD servo control board, mecha cover, head lifter,
head assembly, loading assembly and loading mechanism as-
sembly.
(1) Remove the two screws J attaching the slide cover to fix
cartridge holder assembly from upper surface of loading
assembly. (See fig.15 and 16)
(2) Take out the slide cover to upper surface and then take out
the cartridge holder assembly.
3.3.11 Removing the eject bar
(See fig.15)
• Remove the MD servo control board, mecha cover, head lifter,
head assembly, loading assembly loading mechanism assem-
bly and cartridge holder assembly.
(1) Shift eject bar to direction the arrow until to stop from upper
surface of loading assembly.
(2) Press hook j from bottom surface of loading assembly, and
then take out the eject bar.
Slide ber
J
J
Eject bar
Fig.15
J
Eject bar
Fig.16
Cartridge holder assembly
Eject bar
Hook j
Slide bar
UD base
Cartridge holder assembly
(No.MB496)1-33