Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna DM 230 Operator's Manual

Before starting

!
WARNING! Note the following before

starting:

The machine should be connected to an
earthed outlet socket.
Check that the mains voltage corresponds
with that stated on the rating plate on the
machine.
Ensure you stand firmly. Keep people and
animals well away from the working area.
Make sure that:
• The switch is undamaged. If not, the switch must be
replaced by an authorised repairman.
• The switch is not sticking.
• The drill and its equipment are correctly installed:
- The drill is secured properly.
- If a stand is used, it must be attached to the machine by
the fastening neck on the gearbox.
• Wear personal protective equipment. See instructions
under the heading Personal protective equipment.
• The water cooling or vacuum cleaner (with the help of
adapter) are attached to the machine. Use suitable drill
bits depending on whether water or dry drilling is being
performed. In the event of uncertainty contact your
dealer, your service workshop or an experienced
operator.
Starting
IMPORTANT! Changing gear may only be done when the
machine is switched off. Otherwise there is a risk of
damaging the gearbox.
1 Set the working speed by turning the drill spindle and at
the same time move the gear knob to the required
position.
8 –
English

STARTING AND STOPPING

2 Turn on the water cooling (wet drilling) or switch on the
vacuum cleaner (dry drilling).
3 Hold the machine steady.
4 Press in the switch fully. Also press, if desired, the
TM
Smartstart button.

Stopping

!
WARNING! The drill bit continues to rotate
for a while after the motor has been switched
off. Do not stop the drill bit with your hands.
Personal injuries can occur.
Stop the motor by releasing the power switch.
Cooling
Run the machine unloaded for a minute or two to cool the
motor.