Power Input - Phoenix Gold RSD300.1 Owner's Manual

POWER INPUT

8. GROUND INPUT TERMINAL (B-)
To be wired to the vehicle's chassis for ground.
9. REMOTE TURN-ON INPUT TERMINAL (R)
To be connected to the remote control wire or power antenna lead of the
source unit for remote ON/OFF.
SPEAKER OUTPUT AND FUSING
11. AMP FUSE
Protects the amplifier. If a replacement is necessary, use the same size and
type indicated on the end panel. Never use a fuse with a higher amp rating.
12. PROTECT LED
Red light: Amplifier is in protection - Overheated (will resume play on its
own), Low voltage, Shorted terminal
No light: Amplifier is functional (when power is on)
Note: "Power On" is indicated when the badge/logo on top of the amplifier
lights up blue
Phoenix Gold International, Inc. • 9300 North Decatur St. Portland, OR 97203 • 503.286.9300 • www.phoenixgold.com
�� � ��
10. POWER INPUT TERMINAL (B+)
��� ���
���
�������
13. RMD PORT (RMD - SOLD SEPERATELY)
14. LEFT/RIGHT SPEAKER OUTPUT TERMINAL
MONOBLOCK OWNER'S MANUAL
To be connected to the positive terminal of the vehicle's battery or other
constant +12 V source. Remember to fuse at 12+ source.
This connection allows for connection of our remote voltage display
(optional), so that you can monitor the applied voltage at the amplifier in real
time.
Used to connect the amplifier to speakers. The minimum suggested speaker
wire size is 16 gauge for stereo mode and 14 gauge if the amplifier is going to
be used in mono/bridged operation.
RSd AMPLIFIERS