Quick Start Guide For Preset Programming - Behringer FCB1010 User Manual

Basically, functions in the CONFIGURATION mode are activated as soon as the LED of the respective foot
switch lights up.
s Press UP/ENTER to return to point 2 (DIRECT SELECT), or DOWN to return to point 6 (MIDI channel
selection). In this way, you can easily scroll through the categories DIRECT SELECT, MIDI FUNCTION and
CONFIG.
s Press DOWN (> 2.5 s) in order to quit GLOBAL SETUP.
+
In order to save your settings, it is important to press DOWN (> 2.5 s)!

2.3 Quick Start Guide for PRESET programming

For each of the 100 PRESETS you can determine which MIDI functions shall be transmitted as soon as you
select the respective PRESET. For instance, you can send five different program change instructions, two
controller commands, two different controller values (using the expression pedals) and a Note On command to
the connected equipment at the same time. It is up to you to determine, which commands are stored in a
PRESET. Do as follows to program the functions to be sent with each PRESET:
s Select the PRESET you wish to edit.
s Press DOWN for more than 2.5 s to enter PRESET programming mode. The number in the display disappears
while the green SWITCH 1/SWITCH2 LED in the display starts flashing.
s Use foot switches 1 and 2 to edit the status of the SWITCHES. The current status is indicated by the foot
switch LED and the corresponding SWITCH LED in the acrylic display. For further details see chapter 3.1
“Connections (general)”.
+
Please note that the status of the SWITCHES can also be toggled with UP (SWITCH 1) and
DOWN (SWITCH 2) if DIRECT SELECT is enabled. The only prerequisite is that this function has
been enabled for both SWITCHES in the CONFIGURATION menu (GLOBAL SETUP).
s Confirm with UP/ENTER. The SELECT LED in the display lights up.
s Enable/disable specific MIDI functions by keeping the corresponding foot switch pressed (about 1.5 s).
Once a MIDI function has been activated, the respective foot switch LED lights up. Active MIDI functions
can be selected for editing by shortly pressing their foot switch (as long as SELECT lights up in the display,
i.e. the foot switch LED flashes). The foot switch LED will start flashing immediately. You can choose from
the following functions:
Switch
10/0
Tab. 2.3: Foot switch assignment in PRESET programming mode
+
The MIDI channels for each MIDI function are not set in PRESET programming mode, but
globally for all PRESETS (see chapter 2.2 “GLOBAL SETUP”).
s Confirm your selection with UP/ENTER, in order to start programming the selected MIDI function, or cancel
with DOWN/ESCAPE. Use foot switches 1 through 10/0 or EXPRESSION PEDAL A to enter the parameter
values of your choice.
1) If you selected PROGRAM CHANGE as the MIDI function to be edited, you can now enter a program
change number from 1 through 128 and confirm your selection with UP/ENTER.
MIDI FOOT CONTROLLER FCB1010
MIDI function
1 PRG CHG 1
2 PRG CHG 2
3 PRG CHG 3
4 PRG CHG 4
5 PRG CHG 5
6 CNT 1
7 CNT 2
8 EXP A
9 EXP B
NOTE
2. PROGRAMMING THE FCB1010
Action
Program change command #1
Program change command #2
Program change command #3
Program change command #4
Program change command #5
Controller 1
Controller 2
Expression Pedal A
Expression Pedal B
Transmits a MIDI note
11