Advertisement
14. AUDIO Switch
It is best to set the AUDIO switch to "STBY" (standby) prior to first turning the POWER switch "ON".
When you are ready to begin transmitting, turn the AUDIO switch ON. The STBY position acts as a
mute function that maintains the RF signal but turns off the audio.
15. LCD Display
Multifunctional display shows battery life, audio level and frequency selection. Refer to "LCD Display
Readouts" in this manual for further details.
16. CHANNEL UP/DOWN Buttons
Press the UP and DOWN buttons to change the transmission frequency. Group/Frequency numbers
are shown on the LCD. Keep the button pressed down to fast forward through numbers. Once the
desired Group/Frequency numbers are selected on the transmitter, set the receiver to match. This
functions the same on 35XT and 35HT transmitters if they are included with your kit.
35XT Plug-in Transmitter
18
20
19
22
21
23
24
17
17. Battery Compartment
Open the battery compartment lid by pushing down on the tab and lifting it up. Install two fresh
alkaline "AA" batteries. Make sure the battery polarity is correct as marked inside the battery
compartment.
18. POWER Switch
Turns the 35XT Transmitter "ON" or "OFF".
19. AUDIO Switch
It is best to set the AUDIO switch to "STBY" prior to first turning the POWER switch "ON". When you
are ready to begin transmitting, turn the AUDIO switch ON. The STBY position acts as a mute
function that maintains the RF signal but turns off the audio.
20. MIC Input LEVEL Control
This enables you to adjust the input level of the connected microphone. Using the supplied tool, turn
the dial clockwise to increase, or counterclockwise to decrease the input level.
6
Advertisement
