Download Print this page

Azden 310UDR Instruction Manual page 5

310 diversity camera-mount uhf
Hide thumbs Also See for 310UDR:

Advertisement

7. Battery Compartment
Remove the battery compartment lid by sliding it down. Install two fresh alkaline "AA" batteries. Make
sure the battery polarity is correct as marked inside the battery compartment. Alkaline batteries will
perform best.
8. Headphone Level Adjustment
Turn the dial to adjust headphone audio level. Turn clockwise to increase volume, counter-clockwise
to decrease volume.
9. Shoe Mount Assembly
First loosen the thumb wheel by turning it counter-clockwise. Slide the square foot of the shoe mount
assembly into your camera's shoe mount slot. Secure into place by tightening the thumbwheel by
turning it clockwise until snug. Do not over tighten.
35BT Body-Pack Transmitter
15
16
10. Battery Compartment
Remove the battery compartment lid by sliding it down. Install two fresh alkaline "AA" batteries. Make
sure the battery polarity is correct as marked inside the battery compartment.
11. MIC input Level Control
Located inside the battery compartment, this control enables you to adjust the input level of the
microphone. Using the supplied tool, also found inside the battery compartment, turn the dial
clockwise to increase, or counterclockwise to decrease the input level.
12. POWER Switch
Switches the 35BT Transmitter "ON" or "OFF"
13. MIC Input Jack
Plug the supplied EX-503L Lavalier Microphone into the MIC input jack. In addition to the EX-503L,
other lapel and/or headset microphones with 3.5mm mini plug may also be used with the 35BT. This
input does provide a plug-in power voltage which is required by the EX-503L to operate.
13
10
5
14
12
11

Advertisement

loading

This manual is also suitable for:

35bt35ht35xt