Adcom luna Owner's Manual page 6

4) Take out the Rubber covers (F, G), and then screw
Screws (H, I) out by using Screw driver to detach
the Stand (J) from unit.
5) Screw Screws (K, L, M) out by using Screw driver.
6) Put the Sling (N) into the groove on the unit, and
then screw Screws (K, L, M) in by using Screw
driver.
7) Put the Sling into the groove on the Peg (E) and
hang the speaker on the peg.
Note: don't hang other objects on the peg to
avoid objects dropping down.
Turning the Unit On/Off
Connect the plug at the end of power adapter cable to the
DC IN socket on the back of the unit. Then insert the
power adapter into the mains socket.
Press POWER button to switch unit on. The POWER
indicator lights green.
Press POWER button a second time to switch unit
standby. The POWER indicator lights red.
Press and hold
unit off. The POWER indicator is off.
Your speaker includes a built-in battery, once connected
speaker to mains supply, the battery will be automatically
charged and automatically stop charging once fully
charged.
When battery is charging, the POWER indicator flash
6
POWER button for 3 seconds to switch