Operation; Adjusting The Color Processor Controls - Radio Shack ARCHER 15-1275 Owner's Manual

Even though the controls on the Color Processor are more sensitive and
selective than the controls on your TV, they do interact with each other and with
the controls on your TV, VCR, and other video equipment. Follow the
instructions below and the instructions in the ow ner's manuals for your other
video components.
Refer to "Controls and Functions" on page 4 for details on the effect of each
control and switch.
1. Set all the Color Processor control knobs and switches as described in
"Preparation for Use."
2. Turn on your TV and set it to the same channel as the channel switch on
the RF modulator you are using (or set your TV to "m onitor" ).
3. Set the SOURCE A 'B switch for the desired input source and begin
playback from the selected input source (VCR or video disc player).
4. If you are using an enhancer/stabilizer/m odulator or similar product, adjust it
as described in its ow ner's manual.
5. Adjust the INTENSITY control for the desired picture brightness.
6. If there is no color in the picture (and you are playing a color tape) center
the BURST control and adjust the CHROMA control for the desired amount
of color.
7 Adjust the BURST control for further fine tuning ol the color intensity.
.
8. Adjust the HUE control to achieve the desired color tint (especially flesh
tones).
Continue fine tuning each Color Processor control, along with the controls on
your other video equipment, to obtain the desired results.
Use the BYPASS setting of the MODE switch, at any time, to compare the
processed and unprocessed pictures.

OPERATION

Adjusting the Color Processor Controls