Removing The Rear Panel - JVC HX-Z10 Service Manual

3.1.5 Removing the rear panel

(See Fig.10, 12~16)
• Prior to performing the following procedure, remove the metal
cover and the CD changer mechanism assembly.
(1) Remove holding board by remove a plastic rivet and then
slide out the holding board as shown in fig. 12.
(2) Disconnect the fan wire extending from the fan assembly
from connector CN206
(3) Disconnect the card wire from connector
pack.
(4) Remove four screws F from rear panel.
(5) Release joints b which on right bottom and left bottom of
rear panel. The joint can be release by pull outward the
side of rear panel.
REFERENCE:
Fan assembly and tuner pack will come off with rear panel.
Rear panel
Fan assembly
on the bridge board.
CN1 on the tuner
Plastic rivet
Holding board
Fig.12
Bridge board
CN206
Fig.13
Rear panel
F
F
Fig.14
Fig.15
Rear panel
b
Fig.16
F
Rear panel
b
(No.MB014)1-11