Porter-Cable PCXB115MS Instruction Manual page 23

ON/OFF
AVOID DIRECT EYE CONTACT WITH
LASER (FIG. X, Y)
WARNING
!
1040.10 and 1040.11. Class IIIa Laser
EXPOSURE: Laser radiation is emitted
service dealer.
Laser
warning label
NOTE: If laser labels are missing, damaged
or not clear, contact with the Porter-Cable
Customer Care Center for replacement.
LASER GUIDE ADJUSTMENT
(FIG. Z, AA, BB, CC)
NOTE: All the adjustments for the operation
of this machine have been completed at the
factory. Due to normal wear and use, some
occasional readjustments may be necessary.
WARNING
!
A.
1. Set the saw to a 0° miter and 0° bevel
setting.
angle running across the top and down
the front of a board. This line will serve
as the pattern line (Fig. BB) to adjust the
laser. Place the board on the saw table.
3. Carefully lower the saw head down to
align the saw blade with the pattern
line. Position the saw blade to the left,
center or right side of the "pattern line"
depending on your preference for the
laser line location. Lock board in place
with hold-down clamp.
4. With the saw plugged in, turn on the laser
guide. Your saw has been preset with the
laser line to the left side of the blade.
23
Laser
aperture label