JVC TM-H1700G/E Service Manual page 21

■
DEFLECTION BLOCK
① In the <BLOCK SELECT> screen, press the VOLUME/SELECT –
(DOWN) key.
② Then the DEFLECTION BLOCK adjustment screen is displayed (Fig. 14).
The indication service number on the screen are changed by the vertical
frequency, aspect ratio and scan size of signal for adjustment.
③ The original front key function replaced with the other function displayed
at the lower side of the screen as shown below.
<Function Display>
Data operate (inc/dec) key
Select the service number
<Front Panel Key Arrangement>
■
CONTROL BLOCK
In the CONTROL BLOCK, there are several setting items for decide the
whole system condition. It is no requirement for adjustment in this block.
Please not to change the values. If you had changed the values, you should
put back the values by the method as following.
① In the <BLOCK SELECT> screen, press the VOLUME/SELECT +(UP)
key.
② Then the CONTROL BLOCK adjustment screen is displayed (Fig. 15).
③ The original front key function replaced with the other function displayed
at the lower side of the screen as shown below.
<Function Display>
Data operate (inc/dec) key
Select the service number
<Front Panel Key Arrangement>
< D01 > :
EXIT
Adjustment mode exit key
< C01 > :
EXIT
Adjustment mode exit key
* * * * * * * * * * * *
* * * * * *
* * * * * *
No. 51922
TM-H1700G
DEFLECTION BLOCK
* * * * * * * * * * * *
< D01 > :
EXIT
Fig.14
CONTROL BLOCK
* * * * * * * * * * * *
< C01 > :
EXIT
図 図 図 図 15
21