JVC UX-G375A Service Manual page 10

(3) Disconnect the connector wire from CD board connected to
connector of the Loader board. (See Fig.9)
(4) Disconnect the connector wire from CD board connected to
connector of Traverse mechanism. (See Fig.9)
connector of
connector of
traverse mechanism
loader board
(5) Solder the solder short part of the pickup. (See Fig.10)
(6) Disconnect the card wire from CD mechanism connected
to connector CN102 of the CD board. (See Fig.11)
CN102
1-10 (No.MB729<Rev.004>)
Fig.9
solder short part
Fig.10
Fig.11
3.1.5 Removing the Front panel (See Fig.12, 13, 14)
(1) Remove the two screws J attaching the Front panel. (See
Fig.12)
(2) Disengage two hooks b engaged both side of the Front
panel. (See Fig.13)
hook
(3) Disconnect the connector wire from USB board connected
to connector CN114 of the CD board. (See Fig.14)
CN114
3.1.6 Removing the CD board (See Fig.15)
(1) Remove the four screws K attaching the CD board.
K
J
Fig.12
b
Fig.13
Fig.14
Fig.15
K