Enabling Wi-Fi Signal For Optional App - Dometic CFX75DZW Operating Manual

Operation
7.8

Enabling Wi-Fi signal for optional app

The cooler can be controlled via Wi-Fi using an app that you can install on a
compatible device. The app has control, display and alarm functions.
You find further information on the Dometic website for your country (see back
page). Note that the app may not be available in your country.
The Wi-Fi name of the compressor cooler begins with "CFX". The preset password
is "00000000". You can change the Wi-Fi network name and password individually.
Switching the Wi-Fi signal on or off
➤ Press the "SET" button (fig. 3 4, page 10) six times.
➤ Use the "UP +" (fig. 3 10, page 10) and "DOWN –" (fig. 3 9, page 10)
buttons to switch the Wi-Fi signal on or off.
✓ The desired setting appears in the display for a few seconds. The display flashes
several times and then the current temperature is displayed again.
I
NOTE
• The default setting for the Wi-Fi transmitter is off. For first time use and
whenever power to the device is interrupted, switch on the Wi-Fi
transmitter to use the app.
• The Wi-Fi transmitter uses a small amount of power. For optimal
energy performance switch the Wi-Fi transmitter off if it is not being
used.
Resetting the Wi-Fi to factory settings
In case you have personalized the Wi-Fi settings of your cooling device using the
Wi-Fi app and forgotten your password, you can reset to the factory settings as
follows:
➤ Press the "SET" button (fig. 3 4, page 10) six times.
➤ Hold the "UP +" (fig. 3 10, page 10) button for at least five seconds.
✓ In both displays "rES" will blink several times before returning to the previous
display.
✓ The Wi-Fi settings have been reset to factory settings.
For additional information visit the Dometic website from which you downloaded
the app.
22
CFX75DZW, CFX95DZW
EN