Catalytic Cooking Compartment Panels; Removing And Installing The Door Panels - Bosch HBE5451UC Use And Care Manual

Catalytic cooking compartment panels

The catalytic cooking compartment panels are coated
with self-cleaning enamel.
The surfaces clean themselves while the oven is in
operation. Larger splashes will only be removed after the
oven has been used several times.
Self-cleaning surfaces
The rear and side walls are covered with catalytic
paneling. So not use oven cleaner on the catalytic
panels. Slight discoloration of the enamel does not affect
self-cleaning.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels
from the oven door.
Removing the door panels
Open the oven door fully.
1.
Lock both hinges on the left and right using a locking
2.
pin.
Note: The locking pins must be fully inserted into the
holes in the hinges.
Lift the bottom of the inner panel slightly until the
3.
fastening pins come out of the holder (1).
Carefully lift the top of the inner panel until the
4.
fastening pins come out of the holder (2).
CAUTION
9
When lifting the inner panel, the middle panel
may stick to the inner panel. Make sure that the
middle panel does not fall.
Remove the inner panel.
5.
Remove the middle panel.
6.
Note: The middle panel is kept in place with rubber
bushings rather than retaining pins.
Clean the panels with glass cleaner and a soft cloth.
WARNING
9
RISK OF INJURY
Scratched glass in the appliance door can burst. Do
not use any glass scrapers or strong or abrasive
cleaning agents.
Fitting the door panels
Reinsert the middle panel.
1.
Note: Make sure that the panel is seated correctly.All
rubber bushings must lay flat against the outer panel.
Reinsert the inner panel.
2.
Note: All four fastening pins must engage in the
holders provided for them.
Remove the locking pins and close the oven door.
3.
13