JVC RX-8012VSL Service Manual page 4

RX-8012VSL/RX-8010VBK
Removing each board connected to the
rear side of the audio board
Prior to performing the following procedure, remove
the top cover and the rear panel.
1. Cut off the tie band fixing the harness.
2. Disconnect the connect CN501, CN243, CN205,
CN381, CN361 on the DVD board.
3. Disconnect the harness from connector CN721,
CN722 and CN723.
4. Disconnect the tuner board and audio input board
from connector CN101 and CN301 on the audio
board.
5. Disconnect the video audio board and video board
from connector CN303 and CN201 on the audio
board.
6. Disconnect the S video board from connector CN241
on the audio board.
7. Disconnect the DSP board from connector CN601 on
the audio board.
8. Pull out the plastic pin which prevents from coming
out.
Audio board
CN416
CN101
CN301
CN303
CN201 CN241
Video audio
board
1-4
(See Fig.5 to 11)
CN206
S Video
Video
board
board
Fig.9
CN361
CN381
CN205
CN723
CN731
CN732
Plastic pin
Audio input Video audio
board
board
Tuner
board
CN244
CN101
CN243
CN501
Fig.5
CN721
CN722
Fig.6
DVD board
Fig.7
Video
S Video
board
board
Fig.8
Tie band
DSP
board