JVC RX-8012VSL Service Manual page 3

Disassembly method
Removing the top cover (See Fig.1)
1. Remove the four screws A attaching the top cover
on both sides of the body.
2. Remove the three screws B on the back of the body.
3. Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
1. Disconnect the card wire from connector CN400 on
the audio board and CN402 on the power supply
board in the front panel assembly.
2. Cut off the tie band fixing the harness.
3. Remove the three screws C attaching the front panel
assembly.
4. Remove the four screws D attaching the front panel
assembly on the bottom of the body. Detach the front
panel assembly toward the front.
Removing the voltage selector
Prior to performing the following procedure, remove
the top cover.
1. Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2. Remove the two screws F' attaching the rear panel
on the back of the body.
Removing the rear panel (See Fig.4)
Prior to performing the following procedure, remove
the top cover.
1. Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2. Remove the thirty four screws E attaching the each
boards to the rear panel on the back of the body.
3. Remove the three screws F attaching the rear panel
on the back of the body.
Tie band
(See Fig.2 to 3)
Main
board
CN400
Audio board
(See Fig.4)
RX-8012VSL/RX-8010VBK
Top cover
A
2
A
2
C
Fig.2
D
Fig.3
E E
E
F
F
Rear panel
Fig.4
B
Fig.1
Front panel assembly
C
CN402
Power
supply
board
Front panel assembly
D
Cord stopper
E
F'
F
E
1-3