Connecting Without A Scart Cable; Connecting A Decoder Or Other Equipment - Philips VR400 Operating Manual

Connecting without a scart cable

Switch off the TV set.
Remove the aerial cable plug from your TV set and insert
it into the socket at the back of the video recorder.
2
Plug one end of the aerial cable provided into the
socket on the video recorder and the other end into the
aerial input socket on your TV set.
Insert one end of the mains cable into the mains socket
at the back of the video recorder and plug the other
4
end into the wall socket.
Switch on your TV set and select the programme number
that you have chosen for video playback (see instruction
manual TV set).
Tune in the TV set in the UHF wave band until the
following picture appears.
D The video recorder will now send on channel
CH36/frequency 591MHz:
CONGRATULATIONS ON THE
PURCHASE OF YOUR NEW
PHILIPS VIDEO RECORDER
TO CONTINUE PRESS OK
Then read 'Initial installation' in the chapter 'INSTALLING
YOUR VIDEO RECORDER'.

Connecting a decoder or other equipment

You can connect additional equipment to the
socket. For example: a decoder, a satellite receiver or a
camera recorder.
3
EXT.2 AV 2
5