Table of Contents
Advertisement
2.1.3 Removing the Power supply board (See Figure 6)
• Prior to the following procedure, remove the bottom cover and
the mechanism assembly.
(1) Remove the two screws E attaching the power supply
board.
(2) Remove the five screws F attaching the power supply
board from the rear side.
(3) Disconnect the card wire from the connector CN711 on the
power supply board.
(4) Remove the power cord from the socket P901 on the pow-
er supply board.
*To remove the power supply board more easily, remove
the cap of the optical jack.
2.1.4 Removing the video output terminal board (See Figure 7)
• Prior to the following procedure, remove the bottom cover, the
mechanism assembly, and the power supply board.
(1) Remove one screw G attaching the video output terminal
board.
(2) Remove the two screws H attaching the video output termi-
nal board from the rear side.
1-10 (No.XA001)
Power supply
board
CN711
F
F
Cap of the
optical jack
Fig.6
Fig.7
E
E
P901
G
Video output
H
terminal board
Advertisement
Table of Contents
