Direct Button Operation
When a tape is in the VCP and the VCP power is off, press the
PLAY, REW(ind), or F.FWD button on the VCP. The VCP will
turn on automatically and playback, rewinding, or fast forwarding
will start immediately.
Automatic Playback
When you put a tape in the VCP, the power will come on and
playback will begin automatically.
Automatic Rewind, Off, Eject
When a tape is played or fast forwarded to its end, the VCP will
rewind the tape, stop, turn itself off, and eject the tape. (The VCP
will not operate this way if Repeat Playback is activated. Details are
on page 17.)
Tape Eject
A tape can be ejected with the VCP power on or off (but the VCP
power cord must be plugged in).
Automatic Tracking Adjustment
The VCP has automatic tracking adjustment, which gives you the
best possible picture quality. With some recordings, however, you
may get a better picture using the manual tracking controls (see
below).
Manual Tracking
To adjust the tracking manually during tape playback, press the
TRACKING (Up/Down) buttons on the remote control.
NOTE:
• Tracking is returned to automatic tracking adjustment when a tape is
inserted or when the STOP button is pressed to halt playback.
Before
tracking
adjustment
Automatic Operation Features 19
After
tracking
adjustment