Download Print this page

ActionTec BTM200 Installation Manual page 9

Advertisement

Regulatory Compliance Notices Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device
that are not expressly approved by Actiontec Electronics, Inc may void the user's authority to
operate the equipment.
Declaration of conformity for products marked with the FCC logo – United States only
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry of Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
"IMPORTANT NOTE: The radiated output power of this internal wireless
radio is far below the FCC radio frequency exposure limits.
wireless radio operates within guidelines found in radio frequency safety
standards and recommendations, which reflect the consensus of the
scientific community. The level of energy emitted is far less than the
electromagnetic energy emitted by wireless devices such as mobile phones. However, the use of wireless radios
may be restricted in some situtations of environments, such as aboard airplanes. If you are unsure of
restructions you are encouraged to ask for authorziation before turning on the wireless radio."
Actiontec Electronics, Inc
760 North Mary Ave,
Sunnyvale, CA 94086
United States
The internal
9

Advertisement

loading