Advertisement
4. OEM Installation Procedures of Bluetooth
Please follow the below steps one by one to install the utility and driver software successfully.
1. Take JST connector to plug into the 8-pin connector located on the same side of the PCB
as antenna.
2. Power on your PC and allow Windows to load fully.
3. Windows first time detects the USB device (Bluetooth by HP); click "cancel".
4. Insert the given Installation diskette and then double click the setup.exe file to run setup.
5. Click "Next" in the welcome window.
6. Click the option for to accept the terms in the license agreement, then click "Next".
7. Click "Next" to install to this folder, or click "Change" to install to a different folder.
8. Click "Install" to begin installation of WIDCOMM Bluetooth Software.
9. Click "OK" to disable unsigned deriver warnings.
10. Click "Finish" to complete the installation.
11. Recommended to select "Yes" to restart your PC to make the changes effective when
screen message pop up.
12. If the software dose not fix device's driver, manually install driver from specific location
when the notice pop up.
13. Select "Advance" and click next to continue; browse the driver location
C:\Program Files\WIDCOMM\Bluetooth Software\bin
Then, finish the software installing.
14. Double click the icon of My Bluetooth Places, and place some options of features on the
computer before to begin using Bluetooth, then click "Next".
15. Select a name for your computer and indicate what type of computer it is.
16. Click "Next" to configure the Bluetooth services; otherwise, click "Skip". Go to step 18.
17. To enable a service, place a check in the box next to the service name.
To display the properties panel for a service, click "Configure".
18. If you have another Bluetooth device and you want to configure the way this computer
will use its services, click "Next". Otherwise click "Skip".
19. Select a device that must be in discoverable mode for your computer to find them, then
click "Next".
20. To begin the paring process, enter the PIN code and click "Initiate Paring". Otherwise
click "Skip".
21. Select available service through the selected Bluetooth device, and click "Next".
22. Repeat step 16, or click "Skip".
23. Click "Finish" for the completion of basic Bluetooth configuration.
24. Check "Entire Bluetooth Neighborhood" to search any other available Bluetooth device
for communication.
Please note that it is OEM's responsibility to put the FCC regulatory label containing the words
"contains Tx FCC ID:LNQBTM200".
5
Advertisement
