Wiring The Fault Alarm Contact; Cabling - Planet IGS-620TF User Manual

The wire gauge for the terminal block should be in the
range between 12 and 24 AWG.
Note

2.1.5 Wiring the Fault Alarm Contact

The fault alarm contacts are in the middle of the terminal block
connector as the picture shows below. Inserting the wires, the
Industrial Gigabit Ethernet Switch will detect the fault status of the
power failure and then forms an open circuit. The following illustration
shows an application example for wiring the fault alarm contacts.
1
Fault Alarm Contacts
Insert the wires into the fault alarm contacts
The wire gauge for the terminal block should be in the
range between 12 and 24 AWG.
Note

2.1.6 Cabling

10/100/1000BASE-T and 100BASE-FX / 1000BASE-SX/LX
All 10/100/1000BASE-T ports come with auto-negotiation capability.
They automatically support 1000BASE-T, 100BASE-TX and 10BASE-T
networks. Users only need to plug a working network device into
one of the 10/100/1000BASE-T ports, and then turn on the Industrial
Gigabit Ethernet Switch. The port will automatically runs in 10Mbps,
20Mbps, 100Mbps or 200Mbps and 1000Mbps or 2000Mbps after the
negotiation with the connected device.
16
2 3 4 5
Fault
6
The Fault Alarm Contacts are
energized (CLOSE) for normal
operation and will OPEN when
failure occurs