Lexus IS250 2009 Service Manual page 281

3-5. Other interior features
STEP 2
STEP 3
Repeat the steps above to program another device for each of
STEP 4
the remaining HomeLink buttons.
282
Press and hold one of the
HomeLink buttons and the trans-
mitter button.
HomeLink indicator
changes from a slow to a rapid
flash, you can release both buttons.
If the HomeLink indicator light
comes on but does not flash,
flashes rapidly for 2 seconds
and remains lit, the HomeLink
button is already programmed.
Use the other buttons or follow
the "Reprogramming
HomeLink
tions. ( P. 284)
Test the HomeLink operation by
pressing the newly programmed
button.
If a HomeLink button has been
programmed for a garage door,
check to see if the garage door
opens and closes. If the garage
door does not operate, see if your
remote control transmitter is of the
rolling code type. Press and hold
the programmed HomeLink but-
ton. The remote control transmitter
is of the rolling code type if the
HomeLink indicator light flashes
rapidly for 2 seconds and then
remains lit. If your transmitter is of
the rolling code type, proceed to
the heading "Programming a roll-
ing code system".
When the
light
a
button" instruc-