LG DELUXE HIGH WALL MINI SPLIT Installation Instructions Manual page 12

Connection method of the
connecting cable(Example)
(1) Dismount two-caps on the conduit panel.
(2) Make a hole appropriate for the passage of
connection cable through on cap by tool.
(for low voltage line)
(3) Pass the connecting cable through the hole.
(4) Properly connectthe cable on the terminal block.
(5) Fix the connection cable with clamp cord
provided on the unit not to have strain at the
terminal when the connection cable is pulled
outside up to a 35 pound weight.
(6) Wind the vinyl tape round the connecting cable
for sealing between the surface of the
connection cable and cap.
(7) Mount the taped part of cable on the cap.
(8) Finally, mount the holed cap with the wound
cable on the conduit panel.
Loose wiring may cause the terminal to overheat
or result in unit malfunction. A fire hazard may
also exist. Therefore, be sure all wiring is tightly
connected.
When connecting each power wire to the
corresponding terminal, follow instructions "How to
connect wiring to the terminals" and fasten the wire
tightly with the fixing screw of the terminal plate.
How to connect wiring to the terminals
• For solid core wiring (or F-cable)
(1) Cut the wire end with a wire cutter of wire-
cutting pliers, then strip the insulation to expose
the solid wire about 25mm(15/16")
(2) Using a screwdriver, remove the terminal
screw(s) on the terminal plate.
(3) Using pliers_bend the solid wire to from a loop
suitable for the terminal screw.
(4) Shape the loop wire properly, place it on the
terminal plater and tighten securely with the
terminal screw using a screwdriver.
• For strand wiring
(1) Cut the wire end with a wire cutter or wire-
cutting pliers, then strip the insulation to expose
the strand wiring about 10mm(3/8").
(2) Using a screwdriver, remove the terminal
screw(s) on the terminal plate.
(3) Using a round terminal fastener or pliers,
securely clamp each stripped wire end with a
round terminal.
(4) Position the round terminal wire, and replace
and tighten the terminal screw using a
screwdriver.
\
_Terminal
_ / block
_mUl| jClamp cord
Locknut-- _|j jCap(Reuse)
l\ _ I (_ --Hole
IH
_!forI® voltagelne)
" i,i i ii<.'" Cap(Remove)
/U [ w _.
_Taping
/ [ _ (for sealing)
Powersupply line / Conduit )anel Low voltageline
(1_,230/208V) (connectingcable)
High volta,qe
Solid wire
_Tj
u)
Insulation
Strand wire
_ Round
terminal
Low voltaqe
Looseningthe I J Fasteningthe [ J
ter_e_ina, block LUj wiretightly
Connecting cable
12