AEG 10660GN-MN User Manual page 22

22
amperage is adequate for the
appliance maximum power (see
data label affixed on the back of the
cooker).
earth connection in accordance with
current standards and prescriptions of
the law. All responsibility is disclaimed
if this is not complied with.
switch must be accessible after
installation of the appliance.
When connecting to the mains with a
socket:
standardized plug, suitable for the
load which is indicated on the data
label. Connect the wires making sure
they correspond as shown below, and
remember that the earth wire must be
longer than the phase wires:
letter L (phase) = brown wire
letter N (neutral) = blue wire
symbol
no parts of it ever reach a temperature
of 75 °C.
or shunts as they could cause false
contacts resulting in hazardous
overheating.
When connecting directly to the
mains:
withstand the appliance load, with
a minimum opening between the
contacts of 3 mm.
= green/yellow wire
(earth)
not be cut out by the switch.
Changing the flexible gas hose
In order to guarantee that the gas hose is
always in excellent condition we strongly
recommend changing it on the date you
will find printed on it.
Replacing the electrical
components
removed in order to change the
electrical heating elements, spit motor,
terminal board and power cable.
cable (see the cross section on table
"Technical Features" paragraph),
always keep the earth wire longer
than the phase wires and, in addition,
follow all the instructions given in the
"Electrical connection" paragraph.
to instructions on "Replacing the oven
lamp" paragraph.
generator and the spark electrodes,
the work top has to be removed as
indicated in paragraph "Replacing the
taps and thermostat".
accessory, the commutator and the
indicator lights, remove the front panel
as indicated in paragraph "Taps" .