Cisco Nexus 5600 Series Hardware Installation Manual page 58

Connecting to an Ethernet Port
Caution If the cable does not remove easily, ensure that any latch present on the cable has been released before
continuing.
To remove the cable, follow these steps:
Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 1
Press the release latch on the cable, grasp the connector near the connection point, and gently pull the
Step 2
connector from the transceiver.
Either install a replacement cable in the transceiver (see the
Step 3
section on page
cable.
Cisco Nexus 5600 Series Hardware Installation Guide
3-6
3-5) or insert dust plugs into the cable end of the transceiver and the end of the removed
Chapter 3 Connecting the Switch
"Installing a Cable into an Transceiver"