Cisco Nexus 5600 Series Hardware Installation Manual page 52

Starting the Switch
After the switch boots, verify that the LED operation is as follows:
Step 7
Fan module—Status LED is green.
•
Power supply—Status LED is green.
•
After initialization, the system status LED is green, indicating that all chassis environmental
•
monitors are reporting that the system is operational. If this LED is orange or red, then one or more
environmental monitor is reporting a problem. This system status LED will start to blink when there
is a major environmental alarm indicating that the system will shutdown shortly.
• The Link LEDs for the Ethernet connector should not be on unless the cable is connected.
Note
Step 8 Try removing and reinstalling a component that is not operating correctly. If it still does not operate
correctly, contact your customer service representative for a replacement.
Note
Step 9 Verify that the system software has booted and the switch has initialized without error messages.
If you cannot resolve an issue, contact your customer service representative.
Step 10 Complete the worksheets provided in
reference.
Note A setup utility automatically launches the first time you access the switch and guides you through the
basic configuration. For instructions on how to configure the switch and check module connectivity, see
the appropriate Cisco Nexus 5600 Series CLI configuration guide.
Cisco Nexus 5600 Series Hardware Installation Guide
2-14
The LED for the Ethernet connector port remains off until the port is connected.
If you purchased this product through a Cisco reseller, contact the reseller directly for technical
support. If you purchased this product directly from Cisco, contact Cisco Technical Support at
this URL: http://www.cisco.com/c/en/us/support/web/tsd-cisco-worldwide-contacts.html.
Chapter 2
Appendix G, "Site Planning and Maintenance Records"
Installing the Cisco Nexus 5600 Series Switches
for future