Table of Contents
Advertisement
Electrical
requirements
wWARNING
Electrical Shock Hazard
Plug into a grounded (earthed) outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Before you move your refrigerator into its final location, it
is important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 Volt/60 Hz (Plug 1), 220/240 Volt/50 Hz (Plug 2),
220 Volt/60 Hz (Plug 3) AC only 10 ampere fused and
properly grounded (earthed) electrical supply is required.
It is recommended that a separate circuit serving only this
appliance be provided. Use a receptacle which cannot be
turned off with a switch or pull chain. Do not use an
extension cord.
NOTE: Before performing any type of installation,
cleaning, or removing a light bulb, turn the Refrigerator
Control to OFF and then disconnect the refrigerator from
the electrical source. When you are finished, connect the
refrigerator to the electrical source and reset the Refriger-
ator Control to the desired setting.
Plug 1
Plug 2
Plug 3
Leveling and door
alignment
Leveling the refrigerator properly will help the doors to
close and seal tightly enough to prevent any cooling, frost
or moisture problems. It is important for the refrigerator to
be level for it to operate properly.
1. Plug refrigerator power cord into grounded outlet. Move
refrigerator into place. Remove base grille by grasping
each side and pulling forward. Remove hinge cover.
Place base grille and hinge cover aside on protected
surface.
2. Place a level on top of refrigerator cabinet at the back
and front of cabinet and check that cabinet is level from
side to side. If you do not have a level, open doors and
release doors without shutting them. The doors should
close on their own if refrigerator is level.
If rear of refrigerator is not level, move refrigerator
out of position and disconnect power cord. Check that
the floor is level. If floor is not level, place shims where
rear rollers will be until floor is level. Plug power cord
into outlet and move refrigerator into place. Check that
rear of refrigerator is level from side
to side.
If front of refrigerator is not level, turn roller
adjustment screw until refrigerator is level from side
to side.
Bottom hinge
cover
Roller adjustment
screw
Stabilizing leg
9
Advertisement
Table of Contents
