Philips intelligent remote control User Manual page 37

6 On the remote control, press and hold either the Left or the Right button.
In the Device menu, while holding down the Left or Right button, tap a
device.
With Device menu
open, hold down
the Left or Right
button ...
The remote control flashes the word device .
7 While device is flashing, press and hold the correct button on the source
remote.
When the remote control learns the command, OK flashes briefly on the
display. The remote control beeps and then returns to Learn mode.
If after a few seconds the remote control has not learned the command
successfully, it buzzes, and FAIL appears briefly on the display. See
"Troubleshooting" on page 33.
8 Repeat steps 4 through 7 to program other Device menu items.
9 When you're done, return to Use mode to test the new commands: Tap
to open the Mode menu, and then tap
CHOOSING A NEW DEVICE WITHOUT SWITCHING THE SOURCE
On occasion, you might want to send commands to a device without switching
the source. For example, you might want to rewind the VCR while you're
watching a DVD. For instructions, see "To switch devices without affecting the
source" on page 23.
Learning commands from other remote controls (Learn mode)
... tap the menu
item you want to
program.
.
35