Mercedes-Benz S-Class Coupe Operator's Manual page 205

If a lane-correcting brake application occurs,
display : appears in the multifunction display.
The brake application also slightly reduces vehi-
cle speed.
A lane-correcting brake application can be made
after driving over a lane marking recognized as
being solid or broken. Before this, a warning
must be given by means of intermittent vibration
in the steering wheel. In addition, a lane with
lane markings on both sides must be recog-
nized.
In the case of a broken lane marking being
detected, a lane-correcting brake application
can only be made if a vehicle has been detected
in the adjacent lane. The following vehicles can
have an influence on brake application: oncom-
ing traffic, vehicles that are overtaking and vehi-
cles that are driving parallel to your vehicle.
i
A further lane-correcting brake application
can only occur after your vehicle has returned
to the original lane.
No lane-correcting brake application occurs if:
you clearly and actively steer, brake or accel-
R
erate.
you cut the corner on a sharp bend.
R
you have switched on the turn signal.
R
a driving safety system intervenes, e.g. ESP
R
®
PRE-SAFE Brake or Active Blind Spot Assist.
you have adopted a sporty driving style with
R
high cornering speeds or high rates of accel-
eration.
®
ESP is switched off.
R
the transmission is not in position D.
R
a loss of tire pressure or a defective tire has
R
been detected and displayed.
an obstacle in the lane in which you are driving
R
has been detected.
Active Lane Keeping Assist may not detect other
road users or traffic situations. An inappropriate
brake application may be interrupted at any time
if you:
steer slightly in the opposite direction
R
switch on the turn signal
R
clearly brake or accelerate
R
A lane-correcting brake application is interrup-
ted automatically if:
a driving safety system intervenes, e.g. ESP
R
®
PRE-SAFE Brake or Active Blind Spot Assist.
lane markings can no longer be recognized.
R
Switching on Active Lane Keeping Assist
Press button ;.
X
Indicator lamp : lights up. The
ing Assist On
tifunction display. If all conditions have been
satisfied, a warning or steering intervention
may be made.
If you drive at speeds above 40 mph
(60 km/h) and lane markings are detected,
the lines in the assistance graphics display
( page 217) are shown in green. Active Lane
Y
Keeping Assist is ready for use.
To switch off: press button ;.
X
®
,
Indicator lamp : goes out. The Active Lane
Keeping Assist is deactivated. The
Keeping Assist Off
the multifunction display.
Selecting Standard or Adaptive setting
In the DriveAssist
X
computer, select the
ing Assist function (
Select Standard
X
When Standard
tion occurs if:
Driving systems
Lane Keep‐
message appears in the mul-
Lane
message appears in
menu on the on-board
Active Lane Keep‐
page 220).
Y
or Adaptive.
is selected, no warning vibra-
203
®
,
Z