Table of Contents
Advertisement
7-1-2 Circuit description (FLY-Back Control)
7-1-2 (a) AC Power Rectification/Smoothing Terminal
1) PDS01, PDS02, PDS03, PDS04 : Convert AC power to DC(Wave rectification).
2) PER10 or PEF10 : Smooth the voltage converted to DC.
3) PCD01, PLF01, PCS03, PCD02, PCD03, PLS01, PBS01, PCF01, PCF02 : Noise removal at power input/output.
4) PVA1 : SMPS protection at power surge input (PVA1 pattern open is to remove noise).
7-1-2 (b) SNUBBER Circuit : PCD11, PCD12, PR1, PDS11
Vswitch
dt
0
Toff
7-1-2 (c) Driving circuit
When Vin supplied, driving current Ig occurs throuhg the PRR11. By this IC (=HfexIg) occurs throug the PQR11
and the Vb is inducted to base winding coil NB of PQR11. By inducted Vb, Ib start flow and the PQR11 is saturat-
ed (S/W ON). Ib is constant and Ic increases in propotion to time. After constant time passed Ib become to
shotage and PQR11 is cut OFF (S/W OFF).
Samsung Electronics
Inverted power
by leakage
inductance
Fig. 7-7
PR2
PR3
PR4
PR5
1) Prevent residual high voltage at the terminals of
switch during switch off/Suppress noise.
High inverted power occurs at switch (PIC1) off,
because of the 1st winding of transformer :
(V= LI xdi/dt. LI : Leakage Induction)
A very high residual voltage exists on both terminals
of PQR11 because dt is a very short.
2) SNUBBER circuit protects PIC1 from damage
through leakage voltage suppression by RC,
(Charges the leakage voltage to PER11, PDS11,
PCD11 and discharges to PR1).
t
Fig. 7-8 Driving Circuit
Circuit Operating Descriptions
7-3
Advertisement
Table of Contents
