HP FlexFabric 12500 Series Configuration Manual page 79
Routing
Hide thumbs
Also See for FlexFabric 12500 Series:
- Configuration manual (402 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
<IRF> system-view
[IRF] mdc MDCA
It will take some time to create MDC...
This MDC was created successfully.
# Authorize MDCA to use the LPU in the master's slot 2 and the LPU in the subordinate member's
slot 4.
[IRF-mdc-2-MDCA] location chassis 1 slot 2
[IRF-mdc-2-MDCA] location chassis 2 slot 4
# Assign all interfaces on the LPUs to MDCA.
[IRF-mdc-2-MDCA] allocate interface GigabitEthernet 1/2/0/1 to GigabitEthernet
1/2/0/48
The configurations of the interfaces will be lost. Continue? [Y/N]:y
[IRF-mdc-2-MDCA] allocate interface GigabitEthernet 2/4/0/1 to GigabitEthernet
2/4/0/48
The configurations of the interfaces will be lost. Continue? [Y/N]:y
# Configure MDCA to use up to 40 percent of the total disk space.
[IRF-mdc-2-MDCA] limit-resource disk ratio 40
# Start MDCA.
[IRF-mdc-2-MDCA] mdc start
It will take some time to start MDC...
This MDC was started successfully.
[IRF-mdc-2-MDCA] quit
# Enter the IRF port views of MDC A and bind a physical IRF port to each IRF port.
[IRF] irf-port 1/1
[IRF-irf-port1/1] port group mdc 2 interface GigabitEthernet 1/2/0/1
[IRF-irf-port1/1] irf-port 2/2
[IRF-irf-port2/2] port group mdc 2 interface GigabitEthernet 2/4/0/1
[IRF-irf-port2/2] quit
[IRF] irf-port-configuration active
# Log in to MDCA from the default MDC and bring up the physical IRF ports.
[IRF] switchto mdc MDCA
******************************************************************************
* Copyright (c) 2010-2014 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<MDCA> system-view
[MDCA] interface GigabitEthernet 1/2/0/1
[MDCA-GigabitEthernet1/2/0/1] undo shutdown
[MDCA-GigabitEthernet1/2/0/1] quit
[MDCA] interface GigabitEthernet 2/4/0/1
[MDCA-GigabitEthernet2/4/0/1] undo shutdown
[MDCA-GigabitEthernet2/4/0/1] quit
# Change the device name to MDCA for easy identification of the MDC.
[IRF] sysname MDCA
75
*
*
*
Advertisement
Table of Contents
