HP FlexFabric 12500 Series Configuration Manual page 36

Step
2. Assign a domain ID to the IRF
fabric.
3. Create an aggregate
interface and enter
aggregate interface view.
4. Configure the aggregation
group to operate in dynamic
aggregation mode.
Enable LACP MAD.
5.
6. Return to system view.
7. Enter Ethernet interface view
or interface range view.
8. Assign the Ethernet port or
the range of Ethernet ports to
the specified aggregation
group.
Configuring BFD MAD
When you configure BFD MAD, follow these guidelines:
Command
irf domain domain-id
•
Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate interface
view:
interface route-aggregation
interface-number
link-aggregation mode dynamic
mad enable
quit
•
Enter interface range view:
Method 1:
interface range { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5>
Method 2:
interface range name name
[ interface { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-5> ]
•
Enter Ethernet interface view:
interface interface-type
interface-number
port link-aggregation group number
32
Remarks
The default IRF domain ID is 0.
This command can be executed
only on the default MDC
(Admin).
Use either command.
Perform this step also on the
intermediate device.
By default, an aggregation
group operates in static
aggregation mode.
Perform this step also on the
intermediate device.
By default, LACP MAD is
disabled.
When you use the mad enable
command, the system prompts
you to enter a domain ID. If you
do not want to change the
current domain ID, press enter at
the prompt.
N/A
To assign a range of ports to the
aggregation group, enter
interface range view.
To assign one port to the
aggregation group, enter
Ethernet interface view.
Multichassis link aggregation is
allowed.
Perform this step on the
intermediate device as well.