Setting Timelapse Options; Setting Photo Or Video; Setting Program Start; Setting Program Stop - Moultrie S-Series Instructions Manual

Setting Photo or Video

Choose between Photo, Video or Both. "Both" will take a photo, then a video.
Reset Options
Choose between a set of predefined configurations for the motion detect
capture mode to quickly configure your camera for certain levels of performance.
E

SETTING TIMELAPSE OPTIONS

Set Frequency of Capture
Choose between 10, 30 seconds / 1, 5, 10, 15, or 30 minutes / 1, 2, 3, 6, 12 hours or 1 day.
8

Setting Program Start

MOTION DETECT MODE
Choose between 24 different settings: any hour from MlDNlGHT to 11 PM. This will
PHOTO OR VIDEO
determine what time the camera will wake up during the program and begin its time
X Photo lapse program. Setting to ALWAYS ON will make the camera operate in timelapse
Video
24 hours/day.
Both
MOTION DETECT MODE

Setting Program Stop

RESET OPTIONS
When start time is set, the camera will automatically move to the Stop option. Set the
Stop time after the Start time you already set. This will set the Start and Stop during
X Do Not Reset
Max. Performance the time lapse photography.
Max. Battery
NOTE: Repeat the above steps for each Program #2 to be set.
Factory Defaults
WARNING: If Program #1 is set to Always On, settings for Program #2 will be disabled.
Reset Options
Use to reset your Timelapse options.
TIMELAPSE (TL) MODE
TIMELAPSE INTERVAL
30 minutes
15 minutes
10 minutes
5 minutes
1 minute
30 seconds
TIMELAPSE (TL) MODE
T.L. PROGRAM #1 START TIME
X 6am
5am
4am
3am
2am
1am
TIMELAPSE (TL) MODE
T.L. PROGRAM #1 STOP TIME
X MIDNIGHT
11pm
10pm
9pm
8pm
7pm
TIMELAPSE (TL) MODE
RESET OPTIONS
X Do Not Reset
Factory Defaults
9