1 Layer 2 Multicast Configuration
The multicast flows in the VLAN are forwarded based on IP addresses or MAC addresses.
By default, multicast flows are forwarded based on IP addresses.
----End
1.4.4 Adding an Interface to a VLAN
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a GE interface, an Ethernet interface, or an Eth-Trunk interface.
Step 3 Run:
port hybrid tagged vlan vlan-id
The interface is added to a VLAN.
----End
1.4.5 Adding an Interface to a Multicast Group Statically
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a GE interface, an Ethernet interface, or an Eth-Trunk interface.
Step 3 Run:
l2-multicast static-group { [ source-address source-ip-address ] group-address
group-ip-address } vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> }
The interface is added to the multicast group statically.
----End
1-6
NOTE
If multicast VLAN replication is not configured, the interface of the S9300 that connects to a router and
receives the multicast packets from the router and the interface that connects to users and sends multicast
packets to users must be added to the same VLAN.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Issue 01 (2009-07-28)