Communication Ports - Siemens RUGGEDCOM i803 Installation Manual

RUGGEDCOM i803
Installation Guide
8
Figure 6: RJ45 Console Port Pin Configuration
a
The DSR, RI and DTR pins are connected together internally.
b
The CTS and RTS pins are connected together internally.

Communication Ports

Connect any of the available Ethernet ports on the device to a management switch and access the ROS console
and Web interfaces via the device's IP address. For more information about available ports, refer to
Communication Ports.
Connecting to the Device
1
RJ45
Male
a
1
2
a
3
4
5
6
7
8
1
Pin
Name Description
DB9
Female
6 DSR Data Set Ready
1 DCD Carrier Detect
4 DTR Data Terminal
Ready
5 GND Signal Ground
2 RxD Receive Data
(to DTE)
3 TxD Transmit Data
(from DTE)
b
8 CTS Clear to Send
b
7 RTS Read to Send
a
9 RI Ring Indicator
Chapter 2
Installing the Device
Comment
Reserved (Do
Not Connect)
Chapter 3,
9