Read The Glossary; Pairing To Your Bluetooth Phone; Enhanced Features - Samsung WEP170 User Manual

3

Read the glossary

Read the glossary at the end of this document to familiarize yourself with important
terms used in this User Manual.
Once headset is fully charged, continue with these instructions.
4

Pairing to your Bluetooth phone

Pairing3 will create a unique and encrypted wireless link between two
Bluetooth enabled devices such as your Bluetooth phone and Bluetooth
headset.
1. Ensure the headset is off (see
Turning headset on/off section).
2. Press and hold until you
see the blue indicator light on
constantly (8 seconds or more),
then release* (see Fig. 3).
3. Set your Bluetooth phone to "discover" the headset by following
your phone's instruction guide. Typically, the steps involve going to
a "setup", "connect", or "Bluetooth" menu on your phone and then
selecting the option to "discover" a Bluetooth device.
4. Your phone will find the "Samsung WEP170" headset and ask if you want to
pair with it. Confirm this by pressing "yes" or "ok".
5. Enter passkey or PIN4 = 0000 (4 zeros), then press "yes" or "ok".
4
！IMPORTANT: If pairing was successful, the blue indicator light will
flash 10 times rapidly before going back to flashing every 3 seconds. If
unsuccessful, the light will continue to be on for up to 2 minutes and
you'll need to re-attempt pairing (see steps 3–5 above).
* If you have a Bluetooth phone that supports the hands-free Bluetooth
profile, see Enhanced features section for alternative pairing instructions.
5
Enhanced features (for Bluetooth phones with hands-free profiles)
Enhanced features are available for phones that support the hands-free Bluetooth profile.
Check your phone's instruction guide or contact the phone manufacturer if you are not sure
if your phone supports the hands-free Bluetooth profile.
Once pairing is done, the following headset features will be available when on (idle):
Last number redial (when not on a call)
While the headset is on, press and hold
displayed on the phone. Select the number and then press
Rejecting an incoming call (when not on a call)
When your phone rings, press and hold
Call-waiting (swapping between 2 calls)
When your phone notifies you of another incoming call while you're on a call, press and
hold release to pick up call and put the first call on hold. To swap to the first call,
press and hold for 1 second, release.
Putting a call on hold
While you're on a call, press and hold
call..
for 1 second, release. The call history will be
once to begin dialling.
for 1 second, release.
for 1 second, release. Repeat to retrieve the
5