Table of Contents
Advertisement
Clock/Timer
Setting clock
There are two possible methods for setting the
clock: manually or automatically by using RDS.
Automatic clock setting
Refer to "Setting the RDS clock".
Manual clock setting
1
In standby mode, press and hold CLOCK on
the remote control.
➜
The clock digits for the hours flash.
2
Adjust VOLUME -/+ (or press VOL +/- on the
remote control) to set the hours.
3
Press CLOCK again.
➜
The clock digits for the minutes flash.
4
Adjust VOLUME -/+ (or press VOL +/- on the
remote control) to set the minutes.
5
Press CLOCK to confirm the time.
Setting the timer
The set can be used as an alarm clock, whereby
the selected source (DAB, FM, DISC or USB)
starts playback at a preset time. Make sure the
clock is set before using the timer.
24
1
Press and hold TIMER on the remote control.
➜
TIMER ON and the hours digits start flashing.
2
Adjust VOLUME -/+ (or press VOL +/- on the
remote control) to set the hours.
3
Press TIMER to confirm.
➜
The minutes digits start flashing.
4
Adjust VOLUME -/+ (or press VOL +/- on the
remote control) to set the minutes.
5
Press TIMER to confirm .
➜
TIMER OFF and the hours digits start
flashing.
6
Adjust VOLUME -/+ (or press VOL +/- on the
remote control) to set the hours.
7
Press TIMER to confirm.
➜
The minutes digits start flashing.
8
Adjust VOLUME -/+ (or press VOL +/- on the
remote control) to set the minutes.
9
Press TIMER again.
➜
The source mode now is available for
selection.
0
Press SOURCE repeatedly (or press DAB,
FM, USB, DISC on the remote control) to
select the wake-up source (DAB, FM, DISC or
USB).
Note:
– if you choose FM as the wake-up source, adjust
VOLUME -/+ (or press VOL +/- on the remote
control) repeatedly to select a preset station.
!
Adjust VOLUME -/+ (or press VOL +/- on the
remote control) repeatedly to set the wake-up
volume.
"
Press TIMER to confirm.
➜
The timer is now set and activated.
Note:
– The set will exit from the timer setting mode if
no button is pressed within 10 seconds.
Advertisement
Table of Contents
